Product ID:SV 1747 BLACK SILICONE PASTE, SV 01747
MSDS Date:04/04/1994
FSC:8030
NIIN:00N057538
MSDS Number: BWQVN

FERRO CORP

115 SKYLINE DR
S PLAINFIELD, NJ 07080
US

Emergency Phone: 800-424-9300(CHEMTREC)

Info Phone: 908-756-1225

Preparer: C. LAUER

Cage: FERRC

FERRO CORP.

SOUTH PLAINFIELD, NJ 07080 US

Telephone: 908-756-1225

Cage: 7L111

COPPER CHROMITE BLACK SPINEL; (COPPER CHROMITE)

CAS: 68186-91-4

Fraction By Weight: 50%

OSHA PEL 0.5 MG/M3 (CR) (MFR)

ACGIH TLV: 0.5 MG/M3 (CR) (MFR)

POLYDIMETHYLSILOXANE; (SILICONE)

CAS: 70131-67-8

OSHA PEL N/K

ACGIH TLV: N/K

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:NO Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:INHAL:LOW HAZARD FOR USUAL INDUSTRIAL
HANDLING. SKIN & EYE CONTACT:MAY CAUSE IRRITATION. SKIN
ABSORPTION:LOW HAZARD FOR USUAL INDUSTRIAL HANDLING. INGEST:MAY
CAUSE IRRITATION. THIS PRODUCT CONTAINS ME THYLPOLYSILOXANES WHICH
CAN GENERATE FORMALDEHYDE AT APPROXIMATELY 300F (150C) & ABOVE, IN
ATMOSPHERES (EFTS OF OVEREXP
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ:WHICH CONTAIN OXYGEN. FORMALDEHYDE IS
A SKIN & RESPIRATORY SENSITIZER, EYE & THROAT IRRITANT, ACUTE
TOXICANT & POTENTIAL CANCER HAZARD.
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

First Aid:INGEST:CALL MD IMMEDIATELY . INHAL:REMOVE TO FRESH AIR.
SUPPORT BREATHING (GIVE O*2/ARTF RESP) . EYES:FLUSH IMMEDIATELY
W/LOTS OF WATER FOR AT LEAST 15 MINUTES, OCCASIONALLY LIFTING
EYELID S. GET PROMPT MEDICAL ATTENTION. SKIN:REMOVE CONTAMINATED
CLOTHING & WASH AREA W/SOAP & WATER FOR AT LEAST 15 MINUTES. SEEK
MEDICAL ASSISTANCE IF IRRITATION OR REDNESS DEVELOPS.

Extinguishing Media:ALL STANDARD FIREFIGHTING MEDIA.
Fire Fighting Procedures:USE NIOSH/MSHA APPROVED SCBA & FULL PROTECTIVE
EQUIPMENT .
Unusual Fire/Explosion Hazard:NO UNUSUAL HAZARD WHEN PRODUCT IS IN
DRUMS UNLESS FIRE CAUSES MATERIAL TO HEAT UP OR BURN. VAPORS &
FUMES CAN CAUSE SERIOUS RESPIRATORY PROBLEMS.

Spill Release Procedures:REMOVE ALL SOURCES OF IGNITION. VENTILATE AREA
& MAINTAIN VENTILATION. USE ALL DESCRIBED PROTECTIVE MEASURES &
EQUIPMENT. USE ABSORBANT MATERIAL, SUCH AS CLAY OR SAND, TO COLLECT
& CONTAIN FOR SALVAGE & DISPOSAL.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:DO NOT STORE NEAR FOOD OR FEED. KEEP
IN TIGHTLY CLOSED CONTAINER, STORED IN A COOL, DRY VENTILATED AREA.
PROTECT FROM PHYSICAL DAMAGE.
Other Precautions:DO NOT CUT, PUNCTURE OR WELD ON OR NEAR THIS
CONTAINER. PRODUCT INTENDED FOR INDUSTRIAL USE ONLY!

Respiratory Protection:NIOSH/MSHA APPROVED RESPIRATOR APPROPRIATE FOR
EXPOSURE OF CONCERN . NONE SHOULD BE NEEDED.
Ventilation:USE LOCAL EXHAUST VENT TO MAINTAIN EXPOSURE WELL BELOW PEL.
USE EXPLOSION PROOF MOTORS & WIRING.
Protective Gloves:IMPERVIOUS (RUBBER, NITRILE) (SUPP DATA)
Eye Protection:ANSI APPROVED CHEM WORKERS GOGGS(SUPDAT)
Other Protective Equipment:EYE WASH FOUNTAIN & DELUGE SHOWER WHICH MEET
ANSI DESIGN CRITERIA .
Work Hygienic Practices:WASH HANDS THORO W/SOAP & WATER AFTER HNDLG &
BEFORE EATING/SMOKING. SHOWER AT COMPLETION OF EACH SHIFT. DO NOT
(SUPDAT)
Supplemental Safety and Health
PROT GLOVES:GLOVES. REPLACE EVERY FOUR HOURS OR AS OFTEN AS NEEDED TO
MAINTAIN PROTECTION. EYE PROT:& FULL LENGTH FACESHIELD . HYGIENE
PRACT:TAKE CONTAMINATED CLOTHING/SHOES HOME.

Vapor Density:HVR/AIR
Appearance and Odor:BLACK SILICONE PASTE; RESIN ODOR.

Stability Indicator/Materials to Avoid:YES
NONE SPECIFIED BY MANUFACTURER.
Stability Condition to Avoid:USE PRODUCT W/CAUTION AROUND HEAT, SPARKS,
PILOT LIGHTS, STATIC ELECTRICITY & OPEN FLAME.
Hazardous Decomposition Products:CARBON MONOXIDE, CARBON DIOXIDE.
TRACES OF FORMALDEHYDE MAY FORM AT TEMPS >150C. SILICON DIOXIDE.

Waste Disposal Methods:DISPOSAL MUST BE I/A/W FEDERAL, STATE & LOCAL
REGULATIONS . PACKAGE IN SEPARATE, LABELED, LEAKPROOF, DOT APPROVED
CONTAINERS & TRANSPORT TO AN EPA APPROVED TREATMENT, STORAGE &
DISPOSAL (TSD) FA CILITY.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.